In Resource tree 'Search', type in 9322 to get a smaller selection to choose from.In the following steps, we will add the modules X20DO9322 and X20DI9371 to the configuration.Make sure it is set to ReadWriteMultipleRegisters to both send and retrieve data Click in the FunctionCode column of the DIO packet.Double-click the DIO packet to go into it.In the 'Packets' table, rename the ModbusMasterPacketDigital to DIO.In the Resource tree, under 'B&R-AutomationIOModules', right-click/add a ModbusMasterPacketDigital to the Packets section in the BR-Automation-X20-BC-0087-UDP.Click the BR-Automation-X20-BC-0087-UDP in the Project tree.The ordered Module configuration should now look like this:.In the Resource tree, double-click on AO4-X20AI4222 to add it.In Resource tree 'Search', delete the previous text, and type in 422 to get a smaller selection to choose from.In the Resource tree, double-click on AO4-X20AO4632 to add it.In Resource tree 'Search', delete the previous text, type in 4632 to get a smaller selection to choose from.In the Resource tree, double-click on X20PS9400 to add it.In Resource tree 'Search', type in 9400 to get a smaller selection to choose from.In the following steps, we will add the modules X20PS9400, X20AO4632 and X20AI4222 to the configuration.
Note: You can also double-click on a resource to add it.
See How to Create a system for more information. Set up a Test-systemįirst we set up a System that the B&R I/O can be tested in:Ĭreate a system named BRDemo with a Console application named BRDemoApp, then select Configure mode. This may involve changing the IP address and network mask of an ethernet interface on the machine running CDP Studio to something like 192.168.100.10/24. Plug in the PSU and make sure that the buscoupler is connected via ethernet and reachable from the machine running CDP Studio.
Requirements: A 24 volt power supply unit (PSU), a network cable, and the following B&R equipment: We will set up the modules so that values are looped from the physical outputs to the physical inputs.
This guide demonstrates a system that uses a B&R X20 BC 0087 Modbus Master to transfer analog and digital values to and from a B&R X20 BC 0087 buscoupler with CDP Studio, the independent automation software for open PC based real-time distributed control systems.